Louët

Wooden warping sticks. Set of 16.

This Louet bench is suitable for the Octado loom. The bench, made of lacquered beech, is height adjustable from 23.5” to 27.5”. This bench is shipp...

This Louët bench is height-adjustable for Delta and Megado looms.The bench, in varnished beech, is adjustable from 23.5 in. to 27.5 in.This bench i...

This Louet bench is suitable for the Jane, Klik, Kombo, Magic Dobby, David and Spring looms. The bench, made of lacquered beech, is 57 cm high. It ...

Bobbin for Louët bobbin rack.

The warp tension regulator (often call a tension box) is used with the Sectional Warp Beam and is adjustable to fit any Louet floor loom back beam.

Lisa frame loom is available in 4 sizes. The smallest one is perfect for an introduction to the World of Weaving and comes with a flat shuttl...

This extension kit contains all the hardware needed to add an extra shaft to the Erica 30 craft. This looms can have a maximum of 4 shafts.

Louet's hand bobbin winder attaches easily to a table top, or even the side or shelf of your loom. The winder has an easily removable shaft for r...

Additional pirns for the Louët flying shuttle.Set of 5 cans.

The spool rack is essential for sectional warping and can be used for different other studio tasks. The Louet bobbin rack can hold up to thirty-two...

Louët hand cards are made from European basswood.They are lightweight. Their backs are slightly curved and their handles are ergonomically designed...

Louët hand cards are made from European basswood.They are lightweight. Their backs are slightly curved and their handles are ergonomically designed...

With its near 4 inch width, the Louët Junior carder is particularly suitable for carding fleeces for spinning or for small felting projects.  ...

The Louët Standard carder is a workhorse. With a width of 7 1/2 inches, fleeces of up to approx. 80 grams can be carded. Mixing colors and fibers i...

This accessory to the Louet warp tension regulator is used to measure the warp. The tension regulator also called tension box is used with sectiona...

Footman to treadle connector for all wheels except the S90. This is the part on the bottom of the footman.

This second warp beam is installed on the Louet Jane 40 cm loom. A second warp beam regularizes the tension when warping with different yarn types.

The Megado Dobby drives the Megado loom, selecting harnesses that will be raised in accordance to your weaving pattern.  Unique to the Dobby 2.0 is...

Second Warp beam for Louët David III.

Second warpbeam for Louët Delta Loom.

Second warpbeam for Louët Spring II Loom.

The Irish Tension art yarn flyer has an orifice and wire sliding guides of 20 mm. We have inserted a plastic sleeve inside the wire sliding guides ...

Spring 2 loom is supplied with 8 or 12 shafts. With this extension of 4 shafts and 4 treadles you can turn an 8-shaft Spring into a 12-shaft loom. ...